|
|
Line 53: |
Line 53: |
| | | |
| == v3 connectivity, old == | | == v3 connectivity, old == |
− |
| |
− | === Version 3.x ===
| |
− |
| |
− | If Repetrel doesn't automatically connect to the printer at this time, we may need to manually set the COM port:
| |
− |
| |
− | In Repetrel, click the HELP menu and select "List USB devices on this computer":
| |
− |
| |
− | [[File:Comlink3_listUSB.png|300px|COM Tab]]
| |
− |
| |
− | You should see not only the FT232R USB UART under Devices:
| |
− |
| |
− | [[File:Comlink3_DevsUART.png|300px|Devices & Printers]]
| |
− |
| |
− | But also, under Unspecified, you should see the STMicroelectronics Virtual COM Port:
| |
− |
| |
− | [[File:Comlink3_DevsVCP.png|300px|Devices & Printers]]
| |
− |
| |
− | This should have a com port listed at the end of the name, in parentheses. Double-click to open Properties:
| |
− |
| |
− | [[File:Comlink3_UART_Props.png|300px|Devices & Printers]]
| |
− |
| |
− | Click on the Hardware tab and see if there are any warnings (a hazard icon would be present):
| |
− |
| |
− | [[File:Comlink3_UART_Props_HW.png|300px|Devices & Printers]]
| |
− |
| |
− | If you have the hazard icon, perform the '''[http://hyrel3d.net/wiki/index.php/Drivers| Installing Drivers]''' tasks again.
| |
− |
| |
− | If all looks well, read the port number; this is the port you want to use to connect:
| |
− |
| |
− | [[File:Comlink3_UART_Props_HW2.png|300px|Devices & Printers]]
| |
− |
| |
− | Select that COM port, ensure the rate is set to 38400, click Apply, then click PING:
| |
− |
| |
− | [[File:Comlink3_4.png|300px|Apply and Ping]]
| |
− |
| |
− | You should now be connected over the UART protocol:
| |
− |
| |
− | [[File:Comlink3_5.png|400px|Apply and Ping]]
| |