Difference between revisions of "Hydras"
(Created page with "Category:Hardware Category:Printers {| align="right" | __TOC__ |} == Hydra Models == The Hydras are our Gantry models, introduced in 2016. In these models we move th...") |
(No difference)
|
Revision as of 17:32, 3 May 2017
Contents |
Hydra Models
The Hydras are our Gantry models, introduced in 2016. In these models we move the heads in the X/Y and the bed only in the Z, allowing for faster print speeds and heavier fixturing.
Comparison
The following chart compares and contrasts the various Hydra models:
Designation | Hydra (Freestanding) Floor Models formerly the 16A |
Hydra Bench top Model formerly the 17A | ||
---|---|---|---|---|
Hydra 430 | Hydra 640 | Hydra 645 | Hydra 340 | |
Target Users |
Industrial Manufacturing | Commercial Manufacturing | ||
Image | |
| ||
Placement Mechanism |
Floor Model Gantry Design |
Benchtop Model Gantry Design | ||
Exterior Dimensions, XxYxZ (closed) |
48x35x68 in 1200x875x1400 mm |
41x27x28 in 104x69x71mm | ||
Power Requirements |
15A / 110VAC / 60 Hz 8A / 220VAC / 50Hz |
15A / 110VAC / 60 Hz 8A / 220VAC / 50Hz | ||
Build Volume | 16x12x10 in 400x300x250 mm |
24x16x10 in 600x400x250 mm |
24x16x20 in 600x400x500 mm |
12x16x10 in 300x400x250 mm |
X/Y Printing Speeds |
Up to 40 mm/sec | Up to 40 mm/sec | ||
Enclosure | Heated | Heated | ||
Motion Control | 3-Phase with Closed-Loop Feedback |
3-Phase with Closed-Loop Feedback | ||
Positional Resolution X/Y/Z in μm |
6 / 6 / 1 | 6 / 6 / 1 | ||
Positional Accuracy X/Y/Z in μm |
60 / 60 / 10 | 60 / 60 / 10 | ||
Positional Repeatability X/Y/Z in μm |
30 / 30 / 5 | 30 / 30 / 5 | ||
Precise X/Y Output for Bioplots |
100 μm lines 200 μm spacing |
100 μm lines 200 μm spacing | ||
Precise Z output for Bioplots |
25 μm layers | 25 μm layers | ||
Tool Positions Optional |
Five Ten |
Five | ||
Cold Flow Options |
All EMO, COD, SDS, CSD, DSD and SMH Heads | |||
Warm Flow Options |
All VOL, VCD, KRA and KCD Heads | |||
Hot Flow Options |
All MK1-250, MK2-250 and MK1-450 Heads | |||
Low Power Laser Options |
5w, 808nm, AlGaAs Diode and/or 6w, 450nm, GaN Diode | |||
High Power Laser Options |
40w ~10 μm, CO2 80w, ~10μm, CO2 |
Not Applicable | ||
Spindle Tool Compatibility |
Standard *High Power in Dev. |
Standard | ||
Other Options |
Quiet Storm Fan, Microscope |