Repetrel Download

From Hyrel3D
Revision as of 14:38, 11 May 2018 by Davo (talk | contribs)
Jump to: navigation, search

Please note that this page is not final yet. You can try version 3.0-75_A AT YOUR OWN RISK from hyrel3d.net/downloads/repetrel/repetrel_3.075_A.rar

Install instructions are essentially the same as for v2, but remember to:

  1. Go to Settings > Printer and load the latest config for your model; and
  2. Flash the Motion Controller with the latest HYREL file (ESR adn 30M), or HYDRA file (EHR and Hydra).



Here are instructions for installing the latest Repetrel software and associated applications, drivers, and environment on a new Windows platform.

This procedure should also be followed to give a complete 3.x install over an existing 2.x install.

If you want to upgrade an existing install, follow these directions:

  • From 2.x to 2.865: ...
  • From 3.x to 3.x: ...

These steps should each be done in order, and run as administrator.

Step One Download button.png

Step One installs the following applications and drivers:

  1. ...
  2. ...
  3. ...

Step Two Download button.png

Step Two installs the following applications and drivers:

  1. ...
  2. ...
  3. ...

Step Three Download button.png

Step Three installs the following applications and drivers:

  1. ...
  2. ...
  3. ...

Step Four Download button.png

Step Four installs the following applications and drivers:

  1. ...
  2. ...
  3. ...