MK1-450

From Hyrel3D
Revision as of 18:18, 4 October 2016 by Davo (talk | contribs)
Jump to: navigation, search

The MK1-450 is our high temperature print head, and works with 1.75mm filaments which print at temperatures between 250°C and 450°C.

MK1-450

This includes the following materials:

  • PC (PolyCarbnoate)
  • PEEK (PolyEther Ether Ketone)
  • Ultem

Description

  1. The MK1-450 is fed filament from the top, through low friction tubing (2mm ID, 4mm OD) seated into a 4mm pneumatic fitting.
  2. A cover plate maintains pressure, via a spring, against a rod with two bearings; these bearings keep the filament pressed against and centered on the gibbed (toothed) portion of the drive shaft of the stepping motor.
  3. Beneath this, the filament enters into a 2mm OD PTFE guide tube, which leads the filament to a stainless steel delivery tube (due to temperatures too high for the PTFE) and thence to the brass nozzle. The stainless steel heats up to some extent, allowing for pre-heating of the filament.
  4. At the nozzle, heat is transferred to the filament, whereupon it is forced out through the brass nozzle.

Loading the Head onto the Printer

asdf

Loading material into the Head

asdf

Default Parameters

asdf

Adjustments

asdf


Firmware

asdf

Maintenance

asdf