When I start repetrel I get error messages.
>ER: 12: 255: CAN Unit: Transmit queue full (total errors=53)
It still prints just fine.
Error when booting up.
2 posts
• Page 1 of 1
Error when booting up.
by Coder96 » Sat Jun 24, 2017 8:41 pm
- Coder96
- Posts: 8
- Joined: Wed Feb 18, 2015 6:16 pm
Re: Error when booting up.
by Davo » Thu Jul 06, 2017 10:20 pm
Not sure what causes that, but a reset on the front of the machine has always cleared it out for me.
Hyrel 3D's Primary Simplificator
Ha, ha, made you look!
Ha, ha, made you look!
-
Davo - Site Admin
- Posts: 357
- Joined: Tue Feb 04, 2014 10:53 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests